- #How to completely reformat usb drive used for octoprint install#
- #How to completely reformat usb drive used for octoprint serial#
(2)Please check the options "Save connection Settings" and "Auto connect on server startup" to ensure that the printer will be connected automatically next time when service restarts. Please wait patiently for the connection. Once a connection is successfully made, the state will become “Operational”. Note: (1)The state is initially “off-line”. Then click “Connect” to connect to the printer.
#How to completely reformat usb drive used for octoprint serial#
When you're done, select Serial Port, Baudrate, and then Printer in the interface. It takes a few minutes for the Raspberry Pi to start, please try to refresh the page after a few minutes.Īccording to the interface wizard, complete the registration and setup. Turn on the Raspberry Pi, enter the previously configured address (192.168.60.137) in the browser and log in to OctoPrint. Use a USB cable to connect the printer to the Raspberry Pi. When setting the IP, please the first query the network segment where the LAN is located, and then add a LAN IP.Īfter the SD card is ejected, insert the SD card into the SD card slot of the Raspberry Pi, and connect the power cable and network cable to the Raspberry Pi. Note: Each field should be separated by a space. After the setting is completed, save the file and eject the SD card. Ip= dwc_otg.fiq_enable = 1 dwc_otg.fiq_fsm_enable = 1 dwc_otg.fiq_fsm_mask=0x3 in the first line. Open the cmdline.txt file with Notepad and add Set the static IP for Raspberry Pi to facilitate access to OctoPrint within the LAN. After the SD card is inserted into Raspberry Pi, this boot partition is the system /boot folder) In the computer, you can see a partition called boot (this partition is FAT32 format, and the capacity will be very small. After clicking on the write button, wait for the system image to be written to the SD Card.Īfter writing, do not rush to unplug the SD card. Open the win32diskimager and select the unzipped image -octopi-buster-lite-0.17.0.
#How to completely reformat usb drive used for octoprint install#
Use win32DiskImager to install the image (Octopi) onto the SD Card. (5)Win32DiskImager (writes an image to the SD Card)ĭownload address: (Download without registration) Īfter connecting the SD Card to your computer,open the formatting software, select the SD Card where the disk character is located and click “Format” for format. (4)SD Card formatting tool(formats the SD Card and lets the SD Card act as a start-up disk)